Do you work on Sub-Zero in the Berkeley Hills?

Yes. The hills and North Berkeley remodels are most of our residential Sub-Zero work. We service built-in columns, drawers, and wine units, and we do the sealed-system work in-house under EPA #1279674151528.

The ice dispenser on my 736 quit but water still flows. Is that the board?

Often, yes. The 736TCI and 736TC have a known dispenser control board failure: ice dead, water fine, panel lit. Sub-Zero discontinued the board, but rebuilders we trust carry it. We confirm it's the board, not a harness or dispenser switch, before ordering.

Are you a factory-authorized Sub-Zero shop?

No, we're independent. That means a straight diagnosis and a written quote first. A Sub-Zero is built to be fixed, so the answer is usually repair, and we'll give you a clear repair-or-replace read before touching it.

SUB-ZERO · BERKELEY

Service · All Sub-Zero Models

Sub-Zero Refrigeration Repair · Berkeley, CA

Built-in Sub-Zero repair for the North Berkeley and Berkeley Hills remodels, columns, drawers, and wine storage serviced by an independent shop.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Sub-Zero in Berkeley

Sub-Zero refrigeration in Berkeley.

Berkeley's Sub-Zero work concentrates in the remodels up in the hills and North Berkeley, the houses off Spruce, Euclid, and the streets above the campus where a kitchen redo usually means a built-in Sub-Zero and a wine column or two. We service those as an independent shop, not a factory-authorized dealer, which means an honest diagnosis and a written quote before anything happens, not a parts-changer guessing on the clock.

We dispatch from San Ramon and run Berkeley regularly. The diagnostic is $75 and we waive it when you book the repair. Sealed-system work stays in-house under our EPA #1279674151528, with recovery, evacuation, and a proper weigh-in, because a Sub-Zero seal job done halfway is a several-thousand-dollar callback.

Common repairs we do

What we close on the truck.

Dual-refrigeration units losing one side. The older 600 and 700 series in the hill houses tend to lose cooling on one compartment while the other holds. That's a slow sealed-system leak on one circuit. We read the compressor cycle and suction line, pull the kickplate to inspect the evaporator, and repair and recharge in-house rather than chasing it with a top-off.
Condenser coil and fan service. On the Classic 36" and 48" built-ins the condenser cakes with dust when cabinet trim chokes the grille. We pull the unit, deep-clean the coil, and check the fan bearings. Catching a dry fan motor early keeps it from seizing and overheating the compressor.
Integrated columns drifting out of square. Designer Series integrated columns in these remodels drift out of alignment after heavy use. The hinge cartridge wears, the panel sags an eighth of an inch, and the magnetic seal stops sealing. We've got the tools and the patience to square up a column door so the gasket seats again.

Models we service

Sub-Zero product lines.

Classic Series 36" and 48" built-ins
BI Series built-in
PRO Series
Designer Series integrated columns
Wine storage columns
Refrigerator and freezer drawers

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts and boiler work. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Sub-Zero service in neighboring cities.

More cities

Sub-Zero across our service area.

FAQ

Sub-Zero in Berkeley questions, answered.

Do you work on Sub-Zero in the Berkeley Hills?

Yes. The hills and North Berkeley remodels are most of our residential Sub-Zero work. We service built-in columns, drawers, and wine units, and we do the sealed-system work in-house under EPA #1279674151528.
The ice dispenser on my 736 quit but water still flows. Is that the board?

Often, yes. The 736TCI and 736TC have a known dispenser control board failure: ice dead, water fine, panel lit. Sub-Zero discontinued the board, but rebuilders we trust carry it. We confirm it's the board, not a harness or dispenser switch, before ordering.
Are you a factory-authorized Sub-Zero shop?

No, we're independent. That means a straight diagnosis and a written quote first. A Sub-Zero is built to be fixed, so the answer is usually repair, and we'll give you a clear repair-or-replace read before touching it.

Need Sub-Zero service in Berkeley?

Tell us what is broken. We will quote it.